Looking to get a set of l92 or ls3 heads so my current set up is up for sale. The heads are ported 317 that flow 315-320cfm. The heads were ported by a buddy of mine while we attended SAM. He did a relly nice job and also cut in one of the schools 3 angle valve job which really made a difference with the flow. Everything was flow benched using the schools equipment. These are a relly nice set of heads. It uses a stock set of intake valves, Ferrea supper alloy exhaust valves and also has a set of patroit gold dual springs with titanium retainers and locks. The motor is on an engine stand and the heads can be taken off in mins. I also have a TBSS intake that comes with the fuel rails, map sensor and stock 5.3l fuel injectors. The injectors are not pictured but do come with the sale. The 90mm throttle body is NOT INCLUDED IN THE SALE. Thanks for looking.

Heads with patroit dual valve springs $750
Heads with ls6 springs $550
TBSS intake $250
Vic

 

intake and heads for my prc 2.5 with .650 springs? less than 2k miles. im in houston. Too high of a compression for my turbo setup. pm me if interested.

 

Thanks for the offer but I'm looking for a set of l92 or ls3 heads if you had the prc l92/ls3 I'd trade ya

 

Are these still available?

Thank you

 

Can you give me some more specifics on the heads? How much have they been milled? What would my comp. ratio be on my '00 5.3 if I bolted them on with stock gaskets? I'm looking for a set of decent heads to replace the stockers on my motor now. Might go that route rather than freshen mine up if the price is right.

Thanks, V1