After thinking on it a while...i've decided to pull the system.

so here it is:


2 Diamond Audio M612d4 subs
Size: 12"
Impedance: dual 4 ohms
RMS: 800
Peak: 1600
Mounting depth: 5.9
$130 each

****SOLD****
2 Rockford Fosgate 1001BD mono amps
500 W X 1 @ 4 Ohms RMS
1000 W X 1 @ 2 Ohms RMS
50-250Hz 24 dB variable LP crossover Subsonic filter
RCA Inputs, pass thrus
$200 each

****SOLD****
1 Rockford Fosgate 451s amp
Number of Channels: 2
Min Frequency Response: 20 Hz
Max Frequency Response: 20 KHz
Bridgeable
Signal to Noise Ratio: 100 dB
Bridged Power (Watts x Channels): 450 x 2
Power at 2 Ohms (Watts x Channels): 225 x 2
RMS Power Output (Watts x Channels): 115 x 2 Crossover
High-Pass Crossover Min Frequency: 50 Hz
High-Pass Crossover Max Frequency: 250 Hz
Low-Pass Crossover Min Frequency: 50 Hz
Low-Pass Crossover Max Frequency: 250 Hz
$130

1 NBS Reg Cab truck box
Fits two 12" subs 6.0"-6.5" deep
Tune ported at 32Hz
the box fits nicely behind the seat, but requires some notching of the B-piller plastic panels.
local only: $75

i LOVE this system...but i just want to try something new ( i got the performance bug, ok? :LOL: ). The Diamonds hit very clean, very good SQ, while pushing a good amount of SPL too. The 1001BDs have never gone into protect, never over heated...good condition.

i'll sell the subs, 2 1001bds, and sub box together local for $700.

 

I may be intrested in one of the amps... where are you located again?

Also... does your middle seat move with the rest of the seats? i had to removed my seats to put my box in bc the middle part didnt move... i really wanna replace that piece of crap...

 

i'm located at north richland hills, TX.

Yeah, i pulled the seat and built the amp rack.

 

oh.. post a pic i wanna see how u did that...

I cant really take that whole middle seat out unless i come with with a way to get this one pesky bolt off which has been stripped since i bought the truck.. it wont budge, lol

 

How many notches did you lose on your seats? I don't want to lose too much leg room, otherwise I may be interested.

 

you have to lose one notch at the bottom, but if you do that, the seat doesn't lean back all the way to the window. if you go two notches, the headrest touches the window easy

 

 

looks pretty good, i kno its not done yet. I'm looking for an amp with multiple channels so i can hook the componets up to it... all yours are mono right onyx?

 

no...two mono blocks and one 2 channel...but they're all gone now. all that's left is the diamond audio subs and the box...and at the price i put the M6s at...i dont expect them to last much longer.

 

oh alrighty, good luck with that. Where are you located again?