I have a 6 lug 14bsf 9.5" ring gear from a 92 light duty 2500. It should bolt into any 88-98 half ton as it sits, but a simple pair of perches and shock tabs could get it to bolt under any year truck. As it sits, it has no brakes, but still has the stock drum backing plates. The drums and whatnot was trash, so i figure between that and the fact that most people will go disc, i stripped it down to that, leaving backing plate and wheel cylinders in there (to leave the correct bolts for them...). Its got 4.10s and carrier is open. Everything looked fairly normal for a stock rear end. Avg amt of metal shavings and some typical pitting on the spiders. As with any axle that is 15+ years old, it could use fresh bearings, etc, and atleast needs a wheel seal on one side. I would prefer local pick up, but if i ship, i want to make it worth my time and to be reimbursed in fuel if i have to travel out of town. Looking to get 500$ OBO for it. Email me at WhatsStuckK5@gmail.com with any questions.

 

bump for a good guy

 

Nice rear end, I have one exactly like this sitting in the garage waiting to go in the Blazer, but if not I think it might be too much overkill for the Z-Truck!!!! Good luck with the sell........There are one or two of these sitting in junk yards around town and they want anywhere from $600-$750 guys, so this is a steal.......

 

thanks for teh nice words...

rarely do they go for a decent price...hell, ive seen 8.5" 10bs be sold for 1000$ by LKQ...

and thanks for the bump coop.

 

Location???

 

Augusta, GA

 

Ship to 77077 Buisness address

Houston, TX

 

i will try to get one on the next few days...any clue the best way to ship or do you know if you have a forward air terminal in the area?

 

Try uship.com I had an engine/trans combo shipped to me for $200

 

Thanks man let me know