PerformanceTrucks.net Forums

GM Engine & Exhaust Performance EFI | GEN I/GEN II/GEN III/GEN IV Engines |Small Block | Big Block |

Yet another.... LM7 build

Thread Tools
 
Search this Thread
 
Old Mar 15, 2012 | 01:32 AM
  #11  
Datankid069's Avatar
Datankid069
Thread Starter
Launching!
iTrader: (15)
 
Joined: May 2010
Posts: 239
Likes: 0
From: Pensacola, FL
Default
Originally Posted by swift700
I'd but the stock size first. After installing them, check the clearance. If it's too tight or too loose then you'll need to buy a size bigger or smaller. I had to buy a smaller bearing as my clearances were too tight on my mains.
Good stuff, thanks man
Reply
0
Old Mar 15, 2012 | 10:46 AM
  #12  
Datankid069's Avatar
Datankid069
Thread Starter
Launching!
iTrader: (15)
 
Joined: May 2010
Posts: 239
Likes: 0
From: Pensacola, FL
Default
Left: Truck TB Right: Camaro TB



Im all ready to ship these away to some where that makes them all pretty i.e.: (p&p, potz, or jantzer) I just can't find anything thing but old threads, no websites.
Reply
0
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Adding timing chain tensioner/ dampener to LM7?
lxcoupe
GM Engine & Exhaust Performance
13
Nov 20, 2015 08:43 PM
No boost at part throttle
2500ZL1
FORCED INDUCTION
15
Sep 12, 2015 03:50 PM
08 Chevy Avy 5.3L DoD issue? Am I good now?
MA$TER_E
Tuning, Diagnostics, Electronics, and Wiring
5
Sep 9, 2015 03:14 PM
Herrrrroooo!
screaminian47
New Members
9
Sep 7, 2015 08:20 PM
14 bolt swap. 1350 u-joint driveline that's 27 spline slip yoke? Does it exist?
iregret
GM Drivetrain & Suspension
12
Sep 7, 2015 01:20 PM
Tags
Back to Subforum
GM Engine & Exhaust Performance
View Next Unread
cats




Advanced Search

All times are GMT -5. The time now is 04:16 PM.