I contacted SDPC about the pulley sale they had going on, however that particular sale had ended...... But Jesse was able to make me a deal for the pulleys, both belts and bolt for $209.. I paid for them yesterday at ~noon and I recieved the pulleys the next day!! Talk about fast shipping. I weighed the pulley at it comes in at ~10pounds... I am hopping to install it tomorrow...

Here are some pics..

 

It's a nice pulley setup but it still weighs more than the stock unit and the apc weighs less than both.....

 

ya, I read that but this was a little cheaper and readily available... I will see tomorrow if it makes a difference... I am just trying to finish up all my boltons before I start messing with engine and getting a TC....

 

I have installed 2 of them and had to hone ~.001" out of it with a wheel cyl hone to get them on. They come on the tight side and have instructions for tollerance with it.

 

you should buy this little cam I have, I'd even help with the install, might as well with the balancer already off!

 

what time are you installing the pulley? i'll come over and help ya.

 

SDPC is an awesome place
Let us know how it goes

 

Sometime this afternoon. Do you have a 3-jaw puller?

 

no. i go to autozone and borrow their chrysler harmonic balancer puller its works perfect, i've used it like 4 times.

 

That is what I was planning on doing, I am probably going to get started here in about an hour, if you want to come over early to help that is cool, you still want help with your tranny cooler fitting? I will PM you directions to my house.