Porting question???
Jan 3, 2009 | 04:05 AM
#12
TECH Apprentice
Joined: Jul 2005
Posts: 363
Likes: 1
From: Melbourne, Oz
Here's mine.
Machined the step out of the bottom.
Machined the flange off the top (not needed for my application).
After filing the un needed parts off..started with the wet and dry sand paper.
Finally...polished it on the bench grinder with a sisal polishing wheel.
(can also be 'half shafted' if desired).
Machined the step out of the bottom.
Machined the flange off the top (not needed for my application).
After filing the un needed parts off..started with the wet and dry sand paper.
Finally...polished it on the bench grinder with a sisal polishing wheel.
(can also be 'half shafted' if desired).
Thread
Thread Starter
Forum
Replies
Last Post
bbowerman
GM Engine & Exhaust Performance
10
Jul 26, 2015 10:57 PM
Gadgetized
GM Parts Classifieds
0
Jul 7, 2015 04:40 PM