ok i am running the taylor 10.4 wires on the truck right now. it seems that the asm's only allow certain wires since the tubes are big. which wires are you running with your asm's. does anyone make the ends so that we can make our own set. i guess they would need small ends to be able to run with the asm's as well. so does anyone make the ones we can build. and what wires on your asm's. two of my taylors are bad now.

 

http://www.msdignition.com/1sparkplugwires.htm

 

I know MSD does. I had Taylors on mine until I discovered a burnt connector. I'm running MSD's now, although I like the Taylors better. MSD's are a bitch to put on compared to Taylors.

 

i don't have headers, but i do have taylors.

what a POS. after 2 years of use they went bad. they are sitting back in the box they came in.

 

I have to change my wires. Didn't see that one coming. So are they just longer for clearance purposes?

 

I have ASMs and use MSD wires, I also use the stock heatshields for assurance.

 

I have the MSD's with my Dynatech's they are a tight fit. Just make sure you get the ones made for the trucks, the regular LS1's are way short.

 

I ordered 8.5mm wire & terminals and
made my on.But they keep sending the wrong
ends for the coils ! who makes
the ends for the coils?
Maybe I need to check with MSD again.

 

so the msd wires do fir on cylinders 4 and 3 right. those seem to be the closest for me. if so i will need to order a set then. oh yay i have the round coils so i will be able to use the camaro or vette wires to. they are a little shorter. that is what i have now.

 

This has me wondering now, I am ordering my ASM's Friday from TByrne on sale, and I am running the JBA PowerCables. I know they are designed for the trucks and not the fbody LS1's. But I wonder if they will work with the ASM's? Anybody running these with ASM's or any headers for that matter?