The boots barely touch my pacesetters but ive never had a problem with it. I went with LS2 wires since they bend 90 degrees right after the boot

 

I like those wires Atomic. They are stock LS2 or aftermarket?

 

stock LS2 wires

 

I forgot the part # of my wires, but you can call msd tech support directly. They are very helpful. You need a kit with LS coil connectors on one side, straight boots on the other and a 12" min overall length.

 

I had this issue a while back and my solution wasn't new wires. We found protective "sock" and they're a lot less expensive than the wires. Fiberglass socks cover up to 1200 degrees Fahrenheit and have a few colors to chose from. http://cableorganizer.com/insultherm-spark/

 

im with this guy.. mine touch.. but dont burn...

been on there like 4 yrs tooo...

 

Ive got the taylor heat sleeves, I think i like the fitment of those LS2 wires. Looks good Atomic! Tried a set from my buddys GTO the're to short but the bent is what i need for clearance.

 

Atomic where did u get your wires and what brand are they? Tried looking a couple vehicles up and none of show 90 bend.

 

Ac delco from autozone I think. I went in and asked for trailblazer SS plug wires. About $40.

 

Sweet, thanks! im out the door to check