ok i get about 4 lobes out and it won't come out anymore. i tried to turn wobble twist and it won't come out

 

did you check to see if any of the lifters may not be up all the way or that one may have sliped down a little causing it to hang up?

 

i tried its the gt-1 lg cam and it stick same place everytime i turn the cam around and it get sticky in on spot and its hard to turn and when i pull it out the 4th lobe in get stuck half way out and it won't go anyfurther than the one spot

 

did you have this kind of bind installing it?

 

i don't know its snake eaters and i wasn't there on the install

 

What are you using to hold the lifters up?

 

may need to get a better grip on the cam, rotat the cam as you remove it slowly pulling it out, may have to force it some.

 

how hard can u pull with out worring about pulling the cam bearings loose?

 

the cam bearing is pressed in with a tool, you can get a little ruff with it, check everything on the lifters.

 

the lifters were up i just pushed them all back down and then twisted the cam and pushed them all back up.