EGR block off plate take a look!
Apr 4, 2007 | 12:25 PM
#1
Thread Starter
12 Second Truck Club
iTrader: (7)
Joined: Jun 2006
Posts: 2,093
Likes: 0
From: colorado above 6000 ft.
EGR block off plate take a look!
I Machined a EGR block off plate for my Truck. Let me know what you guys think? Its machined from billet 6061-T6 and uses that factory o-ring to seal
[IMG]
[/IMG]
[IMG]
[/IMG]
[IMG]
[/IMG]
[IMG]
[/IMG] [IMG]
[/IMG] [IMG]
[/IMG]
Last edited by WJ MARK; Apr 4, 2007 at 12:38 PM.
looks sweet!
Apr 4, 2007 | 04:45 PM
#6
Originally Posted by Formulized94
Wow...that looks damn nice, but why did you put that effort into it when gm makes one?
Trending Topics
Apr 4, 2007 | 06:30 PM
#9
huh... so thats where the egr is supposed to go back into the intake.... my intake doesnt have that... ? i was looking for my egr system cause im about put long tubes on.... anybody know why i woulndt have an egr hole i nmy intake? are the truck intakes different from 2001 to 2002?
Last edited by UnrthdxDream; Apr 4, 2007 at 10:18 PM.
Apr 4, 2007 | 09:56 PM
#10
Originally Posted by WJ MARK
sure you could buy a stock part, but who here leaves their stuff stock. I just wanted to eliminatemy egr and replace it with something that looks good.
Well i understand that, but gm makes a plug that does the same thing when the cover is on the intake you do not see it whether it is stock or machined........Do not get me wrong, i give mads props to you for sure. It looks damn good
