Hey guys,

I'm thinking of going with the electronic cut outs. i have dual exhuast on my LS1 '94 Truck w/2 1/2 random cats and 40series flowmasters.

i don't have any good pics at the moment but the setup goes something like this.

6.0L stock manifolds, directly behind them (about 7" of pipe in between) are the cats. driver side goes straight back and hits the flowmaster at the beginning of the bed. the passenger side goes right under the tranny tail and over and along the driver side. the two flowm masters are hung right where the bed and cab meet, then exists over the rearend and out under the roll pan.

my question. where would i place the cut outs?

any ideas?

thanks,

allen