0-60 times after ported tb and ASP pulley install.
#1
Moderator
Thread Starter
Join Date: Feb 2002
Location: Clyde, California
Posts: 1,908
Likes: 0
Received 0 Likes
on
0 Posts
0-60 times after ported tb and ASP pulley install.
I've done a couple of runs after the ported Tb and ASP pulley install and I very happy with the times. Now as I've always said, this is with a stop watch which I know is iffy at best but my times have always been pretty consistent so I confident with these new 0-60 times. Before the install, my 0-60 was in the 6.05-6.2 range with 0-40 time in the same run of 3.05-3.2.. Last night I did a run and this morning I run. Last nights run was 0-40 in 2.91 and 0-60 in 5.95 and this morning the times were 0-40 in 2.86 amd 0-60 in 5.90.. I'm going to go to the track Wednesday night and see if I can get a new best, temp is suppose to be 90*, so I don't know. Overall, I'm pretty happy with these two mods, and the SES light I reported I got from the first time I installed the TB hasn't come back yet.
Jim
Jim
#3
Re: 0-60 times after ported tb and ASP pulley install.
Hell ~.2 off your 0-60 times is pretty good. I'd figure you gained ~12-15rwhp. Not too bad at all. Sub 6 sec 0-60 in a truck is great.
Any ideas on what your 1/4mi times may be? Mid 14's?
Any ideas on what your 1/4mi times may be? Mid 14's?
#4
Moderator
Thread Starter
Join Date: Feb 2002
Location: Clyde, California
Posts: 1,908
Likes: 0
Received 0 Likes
on
0 Posts
Re: 0-60 times after ported tb and ASP pulley install.
Hell ~.2 off your 0-60 times is pretty good. I'd figure you gained ~12-15rwhp. Not too bad at all. Sub 6 sec 0-60 in a truck is great.
Any ideas on what your 1/4mi times may be? Mid 14's?
Any ideas on what your 1/4mi times may be? Mid 14's?
Jim
Thread
Thread Starter
Forum
Replies
Last Post