also witch one is the PR valve? Is that the valve that I would have replaced with the vacuum mod?

 

The presure tape is on the drivers side just forward and up from the linkage.
Would need to be a hydraulic gauge capable of at least 400 psi. I have however see people use the high side gauge from and AC set it works but the fluid will eventually damage the guage. But those sets can be gotten cheaply enough.Remember though the presures can be really high and tranny fluid hot so use the correct line.

 

No the PR valve is the big valve in the pump

 

I was going to add I had to remove a few things to get to the direcr drum to replace those springs that come in the kit.

 

what about the input speed sensor...making it try to move from 3rd or 4th gear instead of 1st

 

Just wondering who the speed sensor would cause this ? are you talking about the front mount speed sensor?

 

Not trying to be a smartass at all, have you checked the fluid level to see if it is full???

 

yea all the basics have been covered, I will be droping it out some time this weekend