Just curious to see what everyone is running for meth setups and what size nozzle/nozzles

Im picking up a snow kit, thinking about doing 1 10gph or 15gph nozzle, having it come on at around 4lbs or so

MY AIT sensor will be right at the top of my charge pipe before it goes into the T/B, will it be an issue to spray say 12-15 inches before that? or is it better to be closer?

 

I have a single 15GPH on a Alky control kit.

 

I have 2x7s. When i go up to 12-14lbs i am going up to 2x10s

 

yea im only planning on being 10-12lbs of boost but we dont have alot of 93 pumps out here so i figure it will be a little safer.
thinking about doing a 8lbs pump tune no meth then have another tune setup for 10-12lbs with a single nozzle

where are you turbo guys mounting your nozzles

 

I have 2x7's also. I tested it and together they do about 15gph with the pump on full. I have it start coming on around 2psi and full at around 12psi, 50/50 water/methanol.

My nozzles are in the charge pipe about 2' before the TB, IAT sensor is in the intake manifold where the EGR pipe went.

I think running two smaller nozzles is better than one big one for more atomization.

 

yea i thought about that also doing 1 just after the intercooler and one about another foot after that

 

12 and 14gph devils own nozzles. 1 post intercooler and one foot from tb. both are pre iat sensor.

 

Ditto , this is what the man , Julio Don advised .

 

good info guys

 

Two 12's from DO at the SC inlet