New intercoolers, but not for GM's.
Jan 31, 2010 | 08:00 PM
#1
Thread Starter
Truck Sponsor
iTrader: (12)
Joined: Sep 2006
Posts: 4,466
Likes: 62
From: Wichita Falls Tx.
New intercoolers, but not for GM's.
NEW T6 build coming soon.!!!!
But for not thought I would share.
Its not a GM IC but figured I would share,we been slammed so not posting much lately. Here is an intercooler we just did for the Lightnings. Its a single pass 6 inches deep, thats 1.5+ over stock, And stock are dual pass units.
This unit is going under a 3.4Whipple should put out over 800hp.
A little longer, alot deeper, and larger inlet/outlet fittings. Mounting flange not welded on yet.
WE were able to keep almost the stock IC depth in place.
stock ic to bar/plate..
But for not thought I would share.
Its not a GM IC but figured I would share,we been slammed so not posting much lately. Here is an intercooler we just did for the Lightnings. Its a single pass 6 inches deep, thats 1.5+ over stock, And stock are dual pass units.
This unit is going under a 3.4Whipple should put out over 800hp.
A little longer, alot deeper, and larger inlet/outlet fittings. Mounting flange not welded on yet.
WE were able to keep almost the stock IC depth in place.
stock ic to bar/plate..
Jan 31, 2010 | 09:05 PM
#4
Thread Starter
Truck Sponsor
iTrader: (12)
Joined: Sep 2006
Posts: 4,466
Likes: 62
From: Wichita Falls Tx.
I was just showing this new set up..LOL We will be offerong 3 stages to help the Lightning guys out. All just bolt right in the factory location, No need to send off the intake and or cut holes in it.
BTW nice old set up.
BTW nice old set up.
Thread
Thread Starter
Forum
Replies
Last Post
