Innovators West OD crank pulley.. Gen4 Escalade/Denali 6.2
#1
Can anyone point me in a good direction to buy one. Got a 2007 Escalade with a 2.8" top on a TVS1900 and we're spinning 8lbs of boost tapering down to 7lbs.
The Escalade has got ARH 1 7/8" ORY with an LEP Stage 1 Blower cam and forged pistons @ -5cc. We're at 10.1:1 CR. Meth is there if needed.
We're hoping to get 11-12lbs out of the TVS1900 and the 6.2! No over drive rear cogs.
What kind of slippage and realistic gain would we see with the O.D. crank and a 2.7" upper. We'll change it out to an 8-rib setup.
Managed to pull 500whp on my Mustangdyno without meth.
I need a vendor who can get me the O.D. kit and 60lb injectors. We've run out of fuel on the 52lbs at top of 3rd.
Our Denali has 60lb injectors with the same mods different cam and meth and is pulling 580hp with 20% left in the injectors.
The Escalade has got ARH 1 7/8" ORY with an LEP Stage 1 Blower cam and forged pistons @ -5cc. We're at 10.1:1 CR. Meth is there if needed.
We're hoping to get 11-12lbs out of the TVS1900 and the 6.2! No over drive rear cogs.
What kind of slippage and realistic gain would we see with the O.D. crank and a 2.7" upper. We'll change it out to an 8-rib setup.
Managed to pull 500whp on my Mustangdyno without meth.
I need a vendor who can get me the O.D. kit and 60lb injectors. We've run out of fuel on the 52lbs at top of 3rd.
Our Denali has 60lb injectors with the same mods different cam and meth and is pulling 580hp with 20% left in the injectors.
#3
#4
Yes, PM Joe at leftcoast32.
Here is his profile on here.
PerformanceTrucks.net Forums - View Profile: leftcoast32
Here is his profile on here.
PerformanceTrucks.net Forums - View Profile: leftcoast32
Thread
Thread Starter
Forum
Replies
Last Post








