Headers & Cam Installed!
08-29-2005, 09:28 AM
#1
TECH Senior Member
Thread Starter
iTrader: (6)
Join Date: Jul 2005
Location: Decatur, AL
Posts: 5,257
Likes: 0
Received 0 Likes
on
0 Posts
Headers & Cam Installed!
Just got done with the pacesetters and ORY + Cam, springs, & pushrods I got from Farmbeau. It sounds great with the Gibbs corsa. No drone at cruise and just a little louder at idle but when you mash the old GO pedal it gets a little noisy! I like it! 
My boost dropped from 11.5 to 9.5. I'm thinking about ordering a 3.00 pulley to get the boost back up where it was. What do any of you boost/tuning guys think will happen with the smaller pulley. Keep in mind I run 93 gas. Will the knock increase to the point were pulling timing will kill the benefits once I get the dyno tune this weekend? I've updated my sig.
My boost dropped from 11.5 to 9.5. I'm thinking about ordering a 3.00 pulley to get the boost back up where it was. What do any of you boost/tuning guys think will happen with the smaller pulley. Keep in mind I run 93 gas. Will the knock increase to the point were pulling timing will kill the benefits once I get the dyno tune this weekend? I've updated my sig.
Thread
Thread Starter
Forum
Replies
Last Post
ARC
GMT 800 & Older GM General Discussion
57
02-21-2022 10:54 AM
Offroadunleashed
Trucks and SUV Classifieds
0
07-20-2015 02:25 PM
all_individual
Silverado SS, Joe Gibbs Editions, SSR
1
07-13-2015 11:01 AM