It WAS a laser detector/blocker, made by Bell. But sucked ***, I have since remvoed it also. I have Blinders on now, which is just a switch and that's next to the passenger airbag under that Bell laser controller.



kb, I really have always liked that. You guys find doing that modification that hard?

 

i likethat, is that a 2 1/16th or is that a 2" also how much work was thta with cutting the backout? anything had to be relocated?

 

How well does the blinders work? I had a rocky mountain radar detector/scrambler and it wasn't worth a crap!!! I need one that works! Or I could just stop speeding

 

It's not that hard, its a standard 2 1/16" gauge. The cluster just unsnaps and I used a 2" hole saw to drill though the face plate and then drilled a hole though the circuit board for the light and vacuum line. There is the provisions for the tranny temp gauge on the circuit board, but it doesn't hurt anything to cut though them. I used my die grinder to finish fit the gauge and then to enlarge the stock bezel to fit around the gauge bezel. If you can remove the glass from the boost gauge without hurting it, I would recommend that, as I get a bit of glare from it in some conditions

 

i see your broke the line on that one hole...was that for the trans gauge?

 

Ya, doesn't hurt anything since its not used in this style of cluster.

 

ok thanks for sharing, might just have to do that