100mm metco pullies?
Feb 6, 2007 | 04:29 PM
#1
100mm metco pullies?
are these really that good? would it be worth the money to put these on? im seeing a little belt slip on the street, it seems to be less than a pound though. but when it was on the dyno it was loosing boost by 5400rpms, it would pull close to 10.5#s until 5200 and then would fall to about 8.5-9#s by 6000rpms. but as i said on the street it doesnt lose near that much.
Feb 6, 2007 | 04:37 PM
#2
Originally Posted by KBOBOZ71
are these really that good? would it be worth the money to put these on? im seeing a little belt slip on the street, it seems to be less than a pound though. but when it was on the dyno it was loosing boost by 5400rpms, it would pull close to 10.5#s until 5200 and then would fall to about 8.5-9#s by 6000rpms. but as i said on the street it doesnt lose near that much.
Feb 6, 2007 | 04:55 PM
#3
Originally Posted by KBOBOZ71
are these really that good? would it be worth the money to put these on? im seeing a little belt slip on the street, it seems to be less than a pound though. but when it was on the dyno it was loosing boost by 5400rpms, it would pull close to 10.5#s until 5200 and then would fall to about 8.5-9#s by 6000rpms. but as i said on the street it doesnt lose near that much.
Feb 7, 2007 | 10:32 AM
#4
Ive got them and have not noticed any belt slip either....i bought them for the bling though....ive got them on my website if you want to get a set. www.inmotionperf.com
Thread
Thread Starter
Forum
Replies
Last Post
echoman
GMT 800 & Older GM General Discussion
2
Aug 22, 2015 01:53 PM
Ram4Pick
GM Engine & Exhaust Performance
9
Jan 27, 2003 01:51 PM