Hello everyone! Been tossing the idea around of putting a full cage in my rcsb silverado. I want to be legal to run 10s in the 1/4 mile. I'll drive it on the street but the truck will not be a dd. what do you guys think this is going to run? Thoughts and suggestions are welcome.
Thanks Dylan

 

It depends on the material used and general prices on material and labor in your area.

It also depends on if it's just a basic install or if it's bent real nice and tight.

Since you weren't specific in what your looking to get it, It could be any were from $1800- $5000

 

Check out my build thread in the projects section. Then call the Madman.

 

G.M Products, 1999 to PRESENT CHEVY PICKUP 10-POINT ROLL CAGE Race Car, Racing, Dragster, Chassis, Roll bars, Cages, Fabrication, Suspensions, Parts, Shocks, Springs, Motor Plates, Brakes, Drivelines, Housings


SKEET recommended this to me.

 

Seems like a decent set up. I can do all the fab work except bending the piping. Has anyone installed it before? How does it look?

 

https://www.performancetrucks.net/fo...-begun-511699/

 

don't know why some of my pics are so big now in that thread, they must be growing.

 

Your truck looks awesome Black4.8. Wonderful job on the cage. Blown06 madman done a great job on yours too! I have been looking at the swracecars set up but not sure about fitment. I want the cage right and a clean look.

 

The only way would be a custom made one.

Have you looked into race shops in your area that build cages?

 

i got the S & W cage, fits very nice to me, little tweaks here and there but nicely done