Think the stock bottom end can handle this turbo? I don't plan to spin past 6400

 

You are out of camshaft way before 6400 anyway, stick to the stockish rpm's to keep you in the power band. Would be pointless to go that high if it can't flow good there.

Stock bottom end should hold 500hp just fine.

 

I just said that cause that's my rev limiter. Shifts at 59-6k. Is that turbo gonna put me at about that at like 8-10lbs

 

I feel like this turbo is gonna end up putting me at like 600, I.hope it can handle it

 

I don't see it being anywhere near that with a stock cam.

Maybe 450-500 is a better ball park. Doing a cam upgrade will open up way more horsepower.

 

I do have a cam, a 220r

 

You're pretty good at providing info so I assumed it's all stock based on your posts.

Just be aware that your long block does not have the better connecting rods so you'll want to be careful on your horsepower goals.

Still expect are around a 450-500 to the tire with a good tune, going alot higher could get into the danger zone. And at that power level it's going to destory the tires on the street anyway at lower speeds. It should be plenty fun still.

 

Yeah 450-500 is all I want. I mentioned my mods half way down. Also have 243 heads