Hey guys, so I'm working on a couple 04-05 trucks right now, speed density on both. Maf is set to fail at 0hz, p0102 and p0103 set to fail on first error, no light. However, after a flash or anytime the codes are cleared, the trucks start, run like crap, die and then start again and I pedal them to keep them running until the code sets, and then they run perfect. Any ideas of what I could be missing?

 

I believe the codes should be set to no error reported

 

I'll pm you a fix later. Not on my computer at the moment and forget the tables.

 

Thank you!

 

I have tried that as well

 

They have to set the error.

 

No change, as I suspected

 

i have been using efilive in 3bar sd for a while and every time i reflash i have to start the truck a few times before it runs right. its never really been a big deal to me, just the cost of using a stock ecm for what it wasnt really designed for.

 

Same here i wish there was a fix for it

 

Wierd, mine starts first time every time after changing tune, and stays running.