I just ordered my HP tune pro suite.Jay and Keith say its a week before shipping.So probably 2 weeks away.
My truck has already been custom programmed by a dyno tuner.426RWHP
5.3 stock internal-Whipple at 8 psi ,46 lb injectors, 160 stat,TR6's and 100 wet shot after blower.2800 Vigilante stall built trans ,4:11 gears shorties with flowmaster cat back.Have drag radials ready to go too.

So where do I go from here? Do not know if it is locked either.
So should I start with that base line in pcm now and modify it or get another users file.install it in a new pcm and use it for a base to start with.

The problem I have is it runs too rich,10.7 at WOT with no juice.(Have On board LM1)
Pinging with the juice at WOT and still rich.
Tuner says WOT is 18 deg and my Aeroforce shows the same.
I have the 2 bar MAP but not installed yet-should I install before the tune?

I know there is no real formula for this stuff but I am determined to get this thing right and Get Quicker than 14.0

 

You got hptuners, so I would get on their forum. Lots of smart, experienced people there. There are guides and FAQs so you may want to look at too.