I just bought hptuners and I am trying to tune my ve table, my question is in all the articles on how to do it it addresses failing the MAF and resetting ltft's and then scanning. When I do this and then paste it into my table, and then reset and scan again my scans look about the same over and over and over..... My question is what else do I need to disable to make this work? I know something else is correcting I just cannot find what it is, I have researched a lot about this and there is very little info on the later versions of HPtuners and my truck, there is a lot of general info and older info and I am looking for something more current and I haven't been able to find it. I know some of the tables have changed but I am not smart enough or familiar enough to know what has changed since version 1.6 or 2.0 was written with most of the stuff out their for the tutorials.
Thanks in advance
Ray (nb tuner and apparently dumb a** as well)

 

all fixed, had my dtc's set for report no error instead of set no mil, ve is now tuned. Thanks bill at hptuners