i got the head gaskets and rod bearings in from a non sponsor. so all i'm waiting for is a mod to mail me some parts and i can begin building the 6.0 back up.

yes slowpo, you should be afraid.


real exciting thread huh?

 

Hells yeah! Get to work!!!!!

 

Well my little mishap just cost me the 6.0 block I was gonna buy so :fu:

 

you have a 6L why buy another one? or was it to sit on a stand looking all perty while some aftermarket parts replaced the weaker stock parts?

 

 

....from what I saw you needed a fuggin' piston more than rod bearings and head gaskets

 

thats what i'm waiting for to come in. but i pulled all pistons out of the motor and i didn't want to chance reusing the same rod bearings. so i ordered some new ones. also, i got my aerotech scan gauge back today from warranty work. too bad i don't have a running truck to see if it works or not.

besides that stuff, i have all the parts in hand or on order to do my dual bottle setup in the bed. two heaters, pressure switch, Y, bottle brackets, etc.

 

WHat pistons and rods are you getting?

 

stock! i'm just concerned with getting it back up and running. wife is on my *** to do something about the garage being a disaster zone. this is the quickest way

 

i don't think i am going to invest a whole lot more into the engine once i'm done with it. i'm gonna start working on the rear suspension