'04 crew cab @ 5250 lbs. Ran 13.41 @ 100mph. I just can't stop bragging. Turned the boost up to 10 psi and ran 1 sec beter than my previous best.

 

well, how did twotone do?

 

Didn't see him run nothing under a 13.10 but of course I think he was sandbaggin or had problems w/ it because he would literally roll out very slowly about 20-30yrds and then take off only to shut down at about the 1000' mark. His MPH was about in the 110 range though...if that matters. His truck was still there when I left at about 11:30pm...

 

He better pull a GD wheelie

 

well sounds like you just the fastest cc title from blownchevy!!

 

yes the 13.1 was all i could do. I put a 31x10.5W tire on the back and it didnt like it. I tried to leave at 15#s and it just bogged and i got a 2.7x 60'. I knew the 60' was bad so i let out about 1/8th mile. I also blew the bearing out of the turbo so now i have to get it rebuilt. I am also gonna go to a 28x10.5W and see if that helps. If not I will stick with the 29x10.5W. Sorry no wheelies or anything for the people that showed up. I was very disappointed and embarrassed. **** happens.

 

Missed opportunity for me. I was after the spot for the fastest, stock block, 5.3. It was in the bag but the spider gears let go on the 2nd launch. Truck went 11.81 @ 113.8 w/ a 1.62 60' on a 100 shot. I did get to put it on a formula w/ nitrous on it. He went 12.27 and I'll bet he wondered what happened.
I still can't believe that 8 or 10 guys could push a 4,480 pound truck onto a goose neck trailer. The trailer is around waist level and the ramps are steep. The truck sits low so we had to use wood blocks to get the frame to clear and it went on a foot or 2 at a time. I think Allen Nelson must have given everyone a little tune up before the exercise began. LOL!
Many thanks to all who helped.

 

Your welcome, did you spend some of your money this week on a come a long lol

 

I blew the silicone connector next to the MAF just after Allen had tune it.

 

Yes, you're welcome and what spider gears are you talking about ??? What kind of set-up you got for a posi in that thing ???