it my not be my profession but i am not with out the skill.

here is my model of the NX-01 enterprise.

 

It wasn't intended to be a shot at you

 

it's ok, i just don't know how i screwed it up.
the only thing i can guess is that i was not drinking when i did it.
it's time for a cold beer any way.

 

Ha, I feel ya on that one. I used to mod xboxes back in high school and the only way I could focus well enough was with a few miller lite's in me

 

Maybe too many resistors.

On the A/C Controller it is a series parallel circuit, where it is 3 lamps in a series and the groups of 3 series lamps in parallel, so you only need 1 resistor for the entire board.

http://www.fullsizechevy.com/forums/...-write-up.html

 

That's a good writeup. I might pull my a/c controls next weekend and try it out.

 

i actually just pulled mine apart yesterday to change out the bulbs to red...but it's not actual bulbs it's little blue condoms on top of a clear bulb (at least it is on mine) either way when i put it back together it blew out hot for a little until i moved the levers up & down & it started blowing out cold but the thing that pissed me off was that i couldn't actually get it all the way apart i took every screw out & when i went to pull it apart it looked like something was still grabbing & i didn't wanna snap it cause i called GM & they're sayin like 295$ for a new one...needless to say the bulbs didn't get changed & i'm just gonna have to figure out another way...

 

give me a call i will pm you i may have what you need

 

i got a used one from ebay for 20 and it works just fine.