its never done

 

Your 100% right on that!
Unless you sell it, then you have to start all over again.

Jim

 

crank is back in the block I will finish building the motor tomorrow and only 7 beers were killed this time instead of the usual 12 so this motor ahs a chance

Is it a bad thing that the motor was built on friday the 13th?

maybe it means it will work right

 

for the last few days I've been debagding my truck, I work on it for about 45mins every morning when I get home... to say the least my thumbs HURT!!! the heat gun really works but still is a pain in the *** to remove all tape that stays stuck, so far far all the thick tape is off now is just some little residue that is left..... I've been using the heat gun with some WD-40 and its been working... but overall the truck is looking alot better.... it will look alot better after the esky handles go on...

 

<---------AP

 

Hey I sent PM's to TX and 1slow....

you guys let me know whats up!!!!!

 

You are added

 

Don't think I will be any faster on this GTG. My wedding on Feb 18th is and will have me pretty much drained.
It will happen sooner or later though. Maybe next time.

Jim

 

Crank came out of the block again Took me damn 2 hours to check all the piston clearances and what do you know 4 counterwieghts had less than 8 thousandths clearance.

 

Damn, what bad luck your haveing with that thing, sorry to hear it, good luck with it. hurry home.