I agree that looks cool...except I'm partial to Budweiser Oh yea, I run amber DRL's.

 

Hey, I'm partial to Budweiser too. In fact, I think I'm gonna go drink one right now.

 

I got ambers too, but i just noticed today as i pulled up behind someone, one of them is out

 

For my 2004, I did a write up on the mod I did, Check it out
I hated the DTRL's and made the Body Control Module turn on the fog lights instead of the DTRL's, I will be changing the DTRL's soon to match the amber side markers, because I purposely have blown bulbs in the place now so they don;t come on.

Good luck

 

Diet Anything.. . .

And someone told me that when changing bulbs make sure and put a bit of diatrolectric (sp?) grease

 

Well, if I could drink non diet sodas, I would. (Diabetes). You didn't know, no harm, no foul.

 

<-- Regular for me.
<-- And diet for you.

 

It's all good in tha hood!

 

Rather than starting up a whole new thread, I'm gonna revive this one that I found by Searching.

How do the 4114 bulbs come out? I went to put amber 3157s in place of the 4114s and do the drls-on-with-the-headlights mod, but the socket appears to be a 2-piece construction where the bulb & a mounting barrel comes out, but the bulb won't come out of the barrel socket. I see the groove along the whole base on both sides & the 4 clips that grab into the groove but no way to get the clips pulled back to allow the bulb to come out. How does the bulb come out? Almost looked like 1 end has notches for a special tool to be slid in to release the notches but that doesn't make sense. Why make the whole headlight so easy to remove with no tools needed & 2 long steel rods that just pull out only to make a bulb that needs a special tool to replace?