do you have any pictures of the wiring? where did you route them? very clean....everything. your steering wheel looks like it has seen better days though

 

thanks a ton everyone!


yeah its been hectic lately and my buddies twin turbo truck finally got running so i was able to sleep a little haha


lol they are just a couple of drop lights slid under the truck at the shop


yessir that is correct

i was at 0% throttle coasting down a hill and BAM!!! no signs nothing. it broke right below the retainer so there was no real damage other than a valve.

lol yeah the steering wheel get beat pretty good.

i will dig some pics up. the harness that goes across the drivers VC is ran aroun the brake fluid reservoir and then everything is ran under the intake to the front. also all of the power wires from the alt to that red box andall that has been tucked down very low since there was plenty of extra wire to push it down. i can remember where everything else went but i used around 30 ft of wire to extend it to where it is lol.

 

did you paint everything yourself, if so what steps did you take to get it done im wanting to do the same.

 

a friend of ours at the shop owns a collision shop and he did it as a trade to add a trans cooler and fix a leaking front axle.

 

looks good

 

looks clean magazine type of engine bay ....

 

Looks good

 

that is sexy, how much did the bezel run ya?

 

i cant remember exactly but i think it was around $100. thats with face, needles, and some other fancy stuff.