My turn. lq4/4l80 swap(GOING BOOST PG. 4)
#42
Got everything tacked up, its going to the welder tomorrow. Still have to plumb in the waste gate and o2 bungs, but I'll do that later. The welder was available tomorrow, so I'm just going to send it as is. Never again will I make pie cuts for something. I will just buy the bends the next time. I've prlly got 10hours in the downpipe.
#50
Thanks bud.
Another little update:
Got set back from my previous startup date, because I broke my oil dipstick. Should have one from the junkyard this afternoon. I'm going to jump on everything tonight. I'm a little worried about my waste gate dragging. Its above the tranny cross member, but I'm afraid it might drag on gravel or something of the like. Any ideas would be welcome. I'm kind of thinking about building a skid plate.
Another little update:
Got set back from my previous startup date, because I broke my oil dipstick. Should have one from the junkyard this afternoon. I'm going to jump on everything tonight. I'm a little worried about my waste gate dragging. Its above the tranny cross member, but I'm afraid it might drag on gravel or something of the like. Any ideas would be welcome. I'm kind of thinking about building a skid plate.