89 tbi on the juice?
#11
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Cabool, Missouri
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
well i was actually thinking about trying to jerry rig my throttle body spacer to where it would work as my plate. then if i do a good job of hiding the lines and someones asks. i can just say what nitrous?
#12
Teching In
Join Date: Jan 2005
Location: Sacramento, CA
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
LOL. I was looking to do the same with a couple of sneaky bottles in my '89. I'm going to stay up with this post so I can figure out what I'll do to mine for more power. I already have exhaust, an air cleaner, drop and rims, and I just got the truck so I have some more to do.
#13
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Cabool, Missouri
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
haha yea, so far from what all ive seen i think it will be pretty easy. i also have exhaust, air cleaner, drop and rims. i also have some mild custom body mods, CAI, chip, and a pretty built 700r4. if you have any messengers or shoot me a pm i can tell you a lot of lil tricks ive figured/found out for these trucks that are on the cheap side.
#14
TECH Addict
iTrader: (5)
Join Date: Nov 2004
Location: Georgia
Posts: 2,533
Likes: 0
Received 0 Likes
on
0 Posts
you cant rig that spacer to work because it wont atomize the fuel and nitrous right. save some money and buy a plate and do it right. if you dont then youll have all kinds of problems.
#15
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Cabool, Missouri
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
well i compared two of them the looked the exact same, i would take the actual spray bar or w/e the correct term is and place it through the center.
if all else fails i will have my buddy @ UMR machine me one.
if all else fails i will have my buddy @ UMR machine me one.
#17
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Cabool, Missouri
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
50 bucks is quite a bit if your in high school, not being able to work many hours, paying for insurance, paying for GAS, trying to build another motor, and have a g/f, i think if i drop the g/f i could make some serious horsepower and it would be cheaper!
but the guy at UMR (engineering skool) has access to CNC and CAD so he can whip me one up to excact specs for only the price of hte stock.
but the guy at UMR (engineering skool) has access to CNC and CAD so he can whip me one up to excact specs for only the price of hte stock.
#19
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2005
Location: Cabool, Missouri
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
ezactly, after i save money on the plate ill have a whole fill and almost another half! haha, my point was just that if you can come up with something cheaper or free, and your on a budget, why pay more?