Just wanted to stop in and say hello..

I am with the company Race Ready Performance and we manufacture exhaust cutouts.. We took the company over about 2 years ago from the previous owner and finally feel like we have settled down and got everything under control. We look forward to being part of the community.

Jacob

 

Welcome to the site, please feel free to post up in our sponsor section and share some pictures and info.

 

Will do for sure... Pretty new to forum rules and posting etiquette. Have basically just been a long time lurker.

Thanks for the welcome.

Jacob

 

Welcome to the site!

Do you guys have a website or link to the products you offer?

 

We sure do.. I seem to always leave out the important stuff.

Home

If you have any questions regarding any of the products feel free to ask.

Jacob

 

I run one of your 4" cutouts then later a 5", both were great! I have used QTP and DMH ones in the past and yours seem to work the best, and you guys are the only ones that make a 5" I believe. I ordered a new switch at one point and customer service was very good.

 

Thanks for you business Atomic.. And yes I do believe you are correct in that we are the only producers of a 5" cutout.. If you have any pics of your setup i would love to see it.. We hardly ever get install pics of our 4 or 5 inch cutouts.

 

Sure, this is on a 4wd silverado regular cab short bed turbo setup with a 5" downpipe.


First installation, obviously very tight in that area with the sewer pipe size exhaust.


I made a dump piece and trimmed the tcase ribs so I could rotate it so the motor is above the bottom.

 

I will be ordering a 4" electric cutout! Do you sell the 4" y-pipe also?

 

Atomic that 5" setup is legit.. What size turbo were you running on that truck?
Also, good call on rotating that motor up out of the way..

03Chevytruck we look forward to your order, and yes we do sell 4" Y pipes.