New to OBDII stuff from GA
#1
New to OBDII stuff from GA
I just jumped into OBDII stuff. I've done some TPI and TBI stuff for a few years.
Now, I've gone off the deep end and am putting a Ramjet 350/4L60E setup in a 41 Chevy pickup streetrod. I'm trying to get Vortec harness/pcm stuff from a 97 L31 to work with the setup. I need all the help I can get.
I've done severa TPI/700R4 setups in streetrods, but first venture into the deep.
Thanks,
Ron
Now, I've gone off the deep end and am putting a Ramjet 350/4L60E setup in a 41 Chevy pickup streetrod. I'm trying to get Vortec harness/pcm stuff from a 97 L31 to work with the setup. I need all the help I can get.
I've done severa TPI/700R4 setups in streetrods, but first venture into the deep.
Thanks,
Ron
#2
TECH Senior Member
iTrader: (28)
welcome, that sounds like an awesome project. Any pics of the '41? Unfortunately I can't give you too many pointers on the conversion.
-Why is it you are using an L31 harness(just curious, no idea if it'll work)?
-I think painless has a harness out for the Gen III conversions though... I might be mistaken but I coulda swore I've seen it used on a similar project.
-Why is it you are using an L31 harness(just curious, no idea if it'll work)?
-I think painless has a harness out for the Gen III conversions though... I might be mistaken but I coulda swore I've seen it used on a similar project.
#3
TECH Fanatic
Join Date: Dec 2004
Location: Houston,Texas
Posts: 1,708
Likes: 0
Received 0 Likes
on
0 Posts
Yes, like Z06 mentioned, painless performance has the harnesses' for the L31 engines. I have a chart that I got from them that I use to check all sensor problems and locations.
Thread
Thread Starter
Forum
Replies
Last Post
drummer0415
GMT 900 Trucks General Discussion
11
10-24-2015 08:16 PM
lxcoupe
GM Parts Classifieds
3
09-25-2015 12:36 PM