Finally got an idle clip - Cammed 6.0L
#1
Thread Starter
Joined: Nov 2009
Posts: 1,102
Likes: 1
From: Central NJ
So after almost 2 years I finally got an idle clip of my truck.
It's a 6.0 with a 216/224 .561/.563 114 LSA Pat G spec'd cam, OBX longtubes, Magnaflow cats, into a single 3" Borla XR1 (the 16" long oval case muffler).
Excuse my ghetto exhaust hanger.
The small amount of lope this cam has comes in around 16 seconds.
http://www.youtube.com/watch?v=TliiG...jBRHEMEZkygesB
It's a 6.0 with a 216/224 .561/.563 114 LSA Pat G spec'd cam, OBX longtubes, Magnaflow cats, into a single 3" Borla XR1 (the 16" long oval case muffler).
Excuse my ghetto exhaust hanger.
The small amount of lope this cam has comes in around 16 seconds.
http://www.youtube.com/watch?v=TliiG...jBRHEMEZkygesB
#3
It sounds good. You can definitely hear it in there. I think if you turned down that idle a little it would be much more noticable. The idle sounds a little high for a cam of that size to me. I turned mine down to 600 with my cam and i dont have any drivability issues but it sounds way more bad *** haha...
Your truck would be an absolute beast with a TVS 1900 on there too... I can only imagine where you would end up if you are already knockin on the doors of a 12. Throw 10#'s at it and you're in high 11 territory for sure.
Your truck would be an absolute beast with a TVS 1900 on there too... I can only imagine where you would end up if you are already knockin on the doors of a 12. Throw 10#'s at it and you're in high 11 territory for sure.
Thread
Thread Starter
Forum
Replies
Last Post
ARC
GMT 800 & Older GM General Discussion
57
Feb 21, 2022 10:54 AM
GMCtrk
FORCED INDUCTION
67
Jul 17, 2015 06:39 PM






