http://dallas.craigslist.org/ndf/cto/1826924592.html

i bought this for the GF to build but she has decided she wants my 53 chevy truck instead so we are selling it. it is already setup for a small block and is straight for the most part. make me an offer, i need it out of my garage...FAST

i also have the engine we were going to put in it, 350 (4 bolt mains) bored .060, crank turned .020/.020 (both fresh from the machine shop), new bearings, ported and polished 58cc heads milled .010 with new valve springs, a complete gasket set, weiand intake, pretty healthy size cam and lifter set (234/244@.050, .488"/.510" lift, 114 lsa), RPC hei distributor with 50k volt coil, melling oil pump, melling timing set, all covers, etc. EVERYTHING is brand new, all you need it rods, pistons, rings and a carb. $600 OBO!!

also have a 2700 stall for a powerglide we were going to put in it, dont know what manufacturer because i bought it at a swap meet. $150 OBO

 

bump..

 

up up up

 

lets try again. make me an offer, worst i can do is say no

 

anyone?

 

someone make me a ridiculous offer, i need this stuff gone

 

Sorry. I decided not to make an offer after I read that the engine needs pistons, rings, and rods.

Oh, well. I'll give you $100.00 and you can keep the manifold, cam, lifters, timing set, and distributor.

Jack