motor will be done friday and im "shoppin" for head gaskets..already goin with a .040 thickness but dont know on the bore. the motor will be 4.030 bore
found some 4.060 cometics on speed engineerings site for $85 then on texas speed they have commetic 4.030 for $150. im sure you can tell which one im wantin to go with..will the 4.060 gasket work?

 

yeah they should work fine

 

I'm sure the 4.06 will, its just barely bigger. I'm going with some .040 3.905bore gaskets on my 5.3

 

okie doke ill get the 4.060 gaskets then

 

119-H1295SP5040S Is the PN on TR's website

They are 85.00 a piece, so 170 for the set.

Texas Speed does however have the 4.030 .040. Just give em a call, might as well get the right ones IMO!

 

guess i need to read a little closer..why would they say a piece i think they would have a higher demand of people buyin a set than one..

 

For people like you to think they are cheaper then what they are!

 

 

no ****..and get pissed off and think they got ripped when they only got one gasket...where did you get yours and what did they cost..i got bitched at askin my other half for some head gaskets..might have to buy her some too i think she just blew a few gaskets..haha

 

hey man just give cometic gaskets a call and have the make the gaskets for the the exact bore size, i was needing a .040" thick gasket on a stock 5.3 bore and they made mine for me

EDIT: oops sorry just saw where derek said that texas speed had them!