When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I install the new transfer case encoder ring inside the gear and I didn't mark the line up marks and now I don't know how to line it back up to to reinstall it
Are you talking about the the little wheel I was telling you about on your other thread? There's some little marks that have to be aligned. I took some screenshots when I got AllData to try to fix the issue on my suburban. It's this one:
Are you talking about the the little wheel I was telling you about on your other thread? There's some little marks that have to be aligned. I took some screenshots when I got AllData to try to fix the issue on my suburban. It's this one:
Is this the neutral position and if so when reinstalling how do I get the transfer case in the right gear for reinstall . I was thinking of plugging it in and switching the the controls to put the case in the right orientation
Is this the neutral position and if so when reinstalling how do I get the transfer case in the right gear for reinstall . I was thinking of plugging it in and switching the the controls to put the case in the right orientation
how do I get the transfer case in the right gear for reinstall
You grab the little shaft thing that the motor works, with some channellocks, and turn it to neutral. Kind of a no-brainer. Which I fully admit, I'm better qualified for than most, having no brain; butt I don't think you'll find it too much of a challenge either.
05-26-2024, 01:48 PM
Lining up new t case encoder gear
