Trying to figure out what I'm going to need here.

I've got two walbros and my truck is an 07, flex-fuel(bigger fuel line i guess), returnless setup. I'm pretty sure the stock lines are going to supply enough fuel. I'm trying to figure out;

1.) how to configure the pumps.

I think I can get some -6 line, a -6 y block and -6 to the factory feed line correct???

2.) How do I want to wire these things? I've read some people run them both on all the time, some don't.

I've found some pretty good build threads but can't really wrap my head around how it works.

Any help is greatly appreciated. I want to swap to e85 and just trying to get everything lined out before we start

 

ur killing me....


Ill tell you how to configure it lol,

Go out to the garage, find your two walbro pumps. Take out your phone, take a picture of them. Use that picture in craigslist add, and SELL THEM!!!!

Take that money, buy a REAL pump and never EVER think about it again. No crazy wiring, no crazy plumbing, easy to mount. DONE PLAYA!

 

well, we can just go ahead and delete this motha fuggin thread then lol

 

OR i was thinking about this also as a cheap alternative.

Keep one of them and put it in the tank to run the motor (give me the other one lol) and then run a cell and pump up front.....Pump gas in the tank, nitrous specific fuel in the cell.....CHEAP and you dont have to go thru all the **** with e85.


DONE

 

if you dont have room under the hood, you could mount the little cell and pump under the bed....