2 Wheel Peel...LOL
#1
I have been doing all my launches in 4WD and I have no idea if it is spinning or not. Well my 60' on my G-Tech are about 2.3 sec so I thought maybe I have too much TM left in it and maybe I could get some more taken out.
I drove out to a quiet spot on the highway and did a launch in 2WD. I brake stalled it up to 2500 rpm and about 2.2 psi boost and let it rip. The rear end started to go sideways and I was off. Two nice long black strips. I figured it was about 50 ft when I went back on the other side of the highway and thought well maybe my bottom end is not that weak after all.
I got curious so today I went back and measured the 2 wheel peel that I left. It went for 100' then disappeared and started again 30' farther along for another 50'. It was still spinning but the black marks were getting too faint to see when they really ended.
Maybe I need more TM put back in. LOL
I drove out to a quiet spot on the highway and did a launch in 2WD. I brake stalled it up to 2500 rpm and about 2.2 psi boost and let it rip. The rear end started to go sideways and I was off. Two nice long black strips. I figured it was about 50 ft when I went back on the other side of the highway and thought well maybe my bottom end is not that weak after all.
I got curious so today I went back and measured the 2 wheel peel that I left. It went for 100' then disappeared and started again 30' farther along for another 50'. It was still spinning but the black marks were getting too faint to see when they really ended.
Maybe I need more TM put back in. LOL
Thread
Thread Starter
Forum
Replies
Last Post
George C....
GMT 800 & Older GM General Discussion
1
Sep 11, 2015 04:45 PM




