looking for a set of 60lb injectors, any brand, new or used.

 

I have a used set of 7 Siemens 60's. I just haven't bought a replacement for the one that went bad. I sent them all off to have them flowtested and 1 was 25% down on flow. All the rest are within 5%. I have the flowsheet. You would just have to buy 1 new one. I'll take $200 for the 7 shipped.

 

hmm, i may take you up on those. After doing some extra reading though im thinking of going with a flow matched set for a little added peace of mind. I just wouldn't want to put a low flowing injector is say, #7 cylinder.

Do the numbers on the flowsheet correspond to a specific injector, so i could tell which ones flow best?

 

Yes.

Keeping a/f ratio concervative will keep you out of trouble when you have differences in air flow per cyl and fuel for example. Flow matching the injectors is best for insurance and being able to get every last hp out of a combo but factory injectors are not even flowmatched.

 

Replied to your PM