I am looking to buy a 2/4 drop for a single cag silverado 2wd. thinking about going with belltech. not sure on how to go about it. and what would be the best way with the best ride. as in spindles, springs such and such. have 2 inch drop shackles on the rear but have stock shackles as well. let me know with some great advice

 

Springs are cheaper, spindles are supposed to keep stock ride but lose turning radius from what i hear. I'd go with bell tech or mcghaughys for hangers or springs, mcghaugys for spindles.

 

Just realized this is on the classifieds but yeah thats my advice.

 

I have a set of 2" Belltech springs for the front, then all you would need would be the hangers for the rear. And fwiw I can't tell any difference between the ride with these and the factory springs.

 

I have the 2" drop shackles for the rear on it right now. and where did you get your springs at? also what about the hangers for the rear? how much did all of that cost you? and did you do it yourself?

 

Cutoff wheel and air hammer, rear hangers come right off and the new hangers bolt on.

 

i have a complete 2/4 drop kit fom ground force, springs up front, shackels and hangers for the rear including the shocks they came off of my 02 rcsb have about 2000 miles on the set up. whent back to stock up front and 2" drop shackels in the rear had to tow a cycle trailer you will have to find out if they will fit though