I have an extra MegaSquirt II Fuel and ignition controller. I also have a stimulator that's been modified for wideband voltage output. Its been fully tested with the stimulator and seem to work fine. This is a fully programmable setup. This are incredible for what they can do vs. the cost. I'm looking to get $400 for the whole setup.

 

TTT
This is the MS computer with a MS 1 chip and also a MS 2 daughter card and also a stimulator for testing and trouble shooting. Anyone care to make an offer? Thanks for looking! Check them out at www.megasquirt.info

 

sounds far too complex for the average joe, or dan like myself.

 

It's really not that complicated, check out this write-up Parish did. He's running one. The hard part is done, I already built the unit.
https://ls1tech.com/forums/showthrea...ght=megasquirt

 

how much is this unit new i am thinking about getting it just didn't know the price tag on them.

is the unit all ready to go are does it still need parts

 

If you bought one from one of the guys the selling prebuilt built units, the main board w/MS1 is $270, the MS2 dauter card in not avalabile till Aug. some time or later is $80, and the stimulater is $75 plus shipping. The only other things you might need is some air and water temp sender and make up or adapter a wiring harness from a prevously fuel injected motor. I'm needing to sell these, any offers?

 

It it ready to go, but may need some modification to fit you application and needs, but these pretty easy to do and there is great documentation in the mega manual here, http://www.msefi.com/msinfo/manual/mtabcon.htm