I have the stock return rails that have been modified to work with the TBSS/NNBS intake. The crossover has been cut and -6an fittings have been welded on. This would be a great way to run the tbss intake on your 99-02 trucks. asking 75 shipped
this is the only picture that I have of them.

the crossover is not included. you will need 2 -6an fittings and about 10" of -6an line

the zip ties are holding the rail down because I messed up the mounting post. the rails are in perfect condition

 

How would this work on an swapped OBS?

 

it bolts up to the gen III/IV truck intakes.

 

What did you do for a throttle body?

 

its a ls2 90mm tb

 

So I've got a 2005 6.0L that I'm planning on swapping in. I believe it's the same intake manifold as the tbss. Are you saying I can get a LS2 90mm tb and it would bolt up to the newer style intake? Is it cable driven? Did you swap to dbw? I'm trying to figure out what all I'd have to get to make the setup work.

Thanks man.

 

The 05 uses a 3 bolt 78mm tb. you would need a 07.5+ or a TBSS intake manifold to run the 90mm tb. My truck came with DBW. I just needed a conversion harness to make it work. This is for a return style fuel system.

 

bump. open to offers

 

Bump.

 

2 bad mines returnless i been thinking of doing the swap but.... i think im doing ok with the new one i got Bump for a good dude