converion parts? what are you looking for besides trans?

 

Crossmember, converter, driveshaft/yoke, wiring harness adapter, dipstick.

 

converter is there with it, dipstick is there too, front of driveshaft is there with yoke, no harness needed just switch the brown wire to the white wires location and leave the white wire out simple as that, i do have the extra speed sensor pigtail and pcm pins as well and if its going in a 2wd i don't think you have to do anything more than slot the trans mounting hole a little bit.

 

The whole center section has to be cut and moved back a few inches. I just want to be sure that the transmission will be in good working condition and not mess up right away.

 

I've done the wiring on two 2wd 4l80e swaps for my buddies and it didn't look like they cut and welded anything?? Maybe they just adding a section to the back, i know i had to cut and weld on my 4wd though. I personally pulled the complete running gear out of the running 2000 nbs rclb my self, truck was rusted real bad which is why we parted it!

 

Im gonna wait on the transmission.

Reduced to $800 plus shipping.