I have a set of Comp Pro-Magnum Roller rockers 1.75 ratio for sale. I need to get rid of these to pay some other debts unfortunately. I am asking for 400obo plus shipping. Shipping should be around 10-15 bucks to most people. These have been used for a total of about 2 months. They are A LOT nicer than the stockers, the roller tip is nice and heavy duty and it comes with a ARP studs with the pushrod guide plates to keep the pushrods much more stable at high RPM. For those that don’t know what Im talking about it’s a plate that the studs go through into the head and it has basically a fork that goes out towards the pushrod and the pushrod goes through it so it doesn’t bounce around when you are spinning the engine up to a high rpm. I really like this feature since with the factory setup IMO there is too much room between the pushrod passage and the rocker arm. I will take some more pics if needed tonight but at the moment I only have pics of them installed since I never planned on selling them but I have no choice I need the money.


In order to install these you have to grind the little lip inside the valve covers for the nut on the rocker stud to clear it so you don’t hear a damn sewing machine noise. Its not a big deal and takes all of 30 minutes to do it right. Here are some pics of the valve covers so you can see how easily it is done.


If you have any further questions email me at cwhicks@tva.gov because I probably wont look at this thread again until tomorrow morning. These are a great set of rocker arms and are very well made. If you have any specific pic request email and Ill post them all tomorrow morning.

Thanks, Cody

 

Tt...

 

Ttt..

 

bump.

 

Come on guys these are good rockers I just need the money now that my engine is toast. Damn nitrous.

 

Ttt..