What do i need to put a 08 intake manifold on my 04 chevy
Jun 21, 2009 | 09:47 PM
#31
Thread Starter
Staging Lane
Joined: Apr 2009
Posts: 76
Likes: 0
From: P town
theres nothing that you can do about the taper in the intake itself...
if you port it out the geometry of the air/fuel ratio is thrown off...
some have done it but i don't think that noone has been sucessful with it...
the only other thing i can think of is to use the eldebrock intake with the 90* elbow on it to get the full potental of your motor...
if you port it out the geometry of the air/fuel ratio is thrown off...
some have done it but i don't think that noone has been sucessful with it...
the only other thing i can think of is to use the eldebrock intake with the 90* elbow on it to get the full potental of your motor...
Jul 5, 2009 | 10:12 PM
#32
Thread Starter
Staging Lane
Joined: Apr 2009
Posts: 76
Likes: 0
From: P town
well i got the motor in again and i'm tunning it a few hours every day...
so far i've noticed that my cams powerband doesn't start until 5000 rpm....
so i'll definitly need the intake for sure and maybe a set of heads...
so far i've noticed that my cams powerband doesn't start until 5000 rpm....
so i'll definitly need the intake for sure and maybe a set of heads...
Last edited by Matt G6007; Jul 5, 2009 at 10:32 PM.
Thread
Thread Starter
Forum
Replies
Last Post