TXsilverado

iTrader: (19)

that motor was a weaker 99 model LS1 and had over 150,000 miles on it with countless bottles shift points as high as 7200...he will be fine

TXsilverado

iTrader: (19)

2 months to get a cam! EPS better not take that long for mine. i could have called up comp directly for my cam but i know Geoff was a good friend of pats so i kicked him some business.

1slow01Z71

iTrader: (36)

Everyone who orders a cam from EPS has to wait a minimum of 6 weeks here lately most tend to go closer to 8 from what Ive read. Ill get order mine through TSP when the time comes since you can build your own on their site and it gets there iwthin two weeks. 6-8 weeks for a cam is rediculous.

TXsilverado

iTrader: (19)

where are you reading this? i havent seen anything like that.

skeet

iTrader: (18)

stew if it helps i ordered my last cam through geoff, it took less than 3 weeks to get it, it was shipped straight to me from comp, i didnt up for the cam doc. from geoff..

BlackGMC

iTrader: (31)

http://www.texas-speed.com/shop/item...d=898&catid=44

1slow01Z71

iTrader: (36)

Hell check your build thread in the truck stop, f4tal waited almost 2 months for his, there is a thread in the lounge on ls1truck about it posted by phantom, I think there was one posted in the truck stop about it. Everyone who orders one here lately seems to have to wait forever for them.

06blackedout

iTrader: (10)

hey luke when you were origanally going to go with the 5.3 with milled .35 243s and using the ls7 lifter what pushrod length did u plan on using.i have a set of 7.35 already but not sure