Going to a Vic Jr with my Whipple SC and getting rid of the truck intake.

Are there other holes I need to drill into the intake? i.e. Brake Vacuum, Sensors, PCV, etc......? I will also have a Vic Elbow on top.

I plan on deleting the EVAP line so dont worry about that one, but is there another hole, somewhere, that I need?

Thanks

Chad

 

a whipple and a vic jr? the whipple replaces the intake so idk how you would use the vic jr..maybe if it was a side slinger but then i still dont know if it would work

 

if its a side mount you would have to get alittle creative with the charge side

 

Yep.
That's what I plan on doing with my setup as well, with a front mount IC.

 

Yes, its a side mount. Never seen one until I found one locally from a guy who was selling his. Strange looking thing but he said he made good power with a stock motor. I figure with a 383 c.i. and a 4" stroke should be an awesome daily driver. Squirt a little giggle juice in it and it could be dangerous!

The only issue I see with the side mount SC is the discharge underneath the it that goes to the intake. I will have to have a pipe fabbed to make that connection, that's going to be interesting.

The intake, Vic Jr, is what I am questioning. Are there other places that need to be drilled, tapped, welded, glued or otherwise secured to mimic the same components on the factory intake?

Chad

 

my vic jr has places for the booster and the fpr reference....at the same time you'll loose the evap...

 

Thanks

Chad