I bought a used raceready e-cutout recently and I can't get it to work.

I bought a NEW harness and SWITCH and it has good power and ground going to it but when I hit the switch nothing happens. The only used part on it is the plate and motor.

Any advice on what it could be? Bad motor or possible bad wiring?

 

also, what kind of amp draw do these make, all the vids I have seen they just tap into an ignition wire.

 

not 100% sure but i think you can just hook it straight to the battery to check the cutout itself. if that don't work, i would say the motor is bad.

 

Yea I just talked to raceready and they said try that to elimate the possibility of it being a bad wiring harness or switch.

If this dosen't work he said the motor is bad.